Safety Check:

 

Make sure that you understand and observe all instructions and personal safety procedures when carrying out the following tasks. If you are unsure of what these are, ask your technician.

 

Always follow any manufacturer’s personal safety instructions to prevent damage to the vehicle you are servicing.

 

Important Note : replacing injection fuel filter is the technical person's responsibility.

Replacing Sequence

 

 

 

 

1. Locate fuel filter

Refer to the vehicle service manual to identify the location and type of fuel filter, and the correct procedure for removing and replacing it.

 

 

 

 

2. Remove static pressure from fuel system

If the engine is fitted with an electric fuel pump, locate the fuel pump fuse using the service manual, and remove it.Start the engine and wait for it to stop as it runs out of fuel. Then, Switch the ignition off.

 

 

3. Obtain correct replacement

Obtain the correct replacement filter and components from FAC products.

 

 

4. Using correct equipment,removing filter

 

Loosen the clamps on the fuel line on the engine side of the filter at the outer end of the hose and disconnect it. If necessary drain any excess fuel into the fuel proof container.

 

 

5. Install carbureted system filter

 

Connect the new FAC filterhose and tighten the clamp. Make sure that you have the filter facing the right direction via the flow indicator arrow pointing towards the engine.Then remove the old filter and reconnect the new one to the fuel intake.

 

 

6. Remove the old fuel filter

In a fuel injected system, the fuel is under greater pressure, so the fuel lines are normally made of metal which are not replaced at the same time as the filter. Using the correct tool, loosen the metal line connectors and remove the filter, catching any leaking fuel in a fuel-proof container.

 

 

7. Install The New fuel filter

 

Connect the new filter and tighten the line connectors. Make sure that you have the filter facing in the right direction, via the flow indicator arrow pointing towards the engine.Finally, remember to replace the fuel pump fuse.

 

Note:

All FAC injection products have written instructions for replacing procedures located on both packing and housing body.